10.2MM SPARK PLUG WIRE SET CHEVY/GMC TRUCKS SILVERADO SIERRA 4.8, 5.3, 6.0 and 8.1 ENGINES 13 INCH LONG WIRES // PART # 32829

$ 44.95


             VMS Racing HIGH HEAT (600 DEGREES) 10.2MM Spark Plug wires for the Chevy/GMC/Cadillac/Buick trucks & SUV's with SOME of the 4.8, 5.3, 6.0 and 8.1 litre engines. This is one of the best engineered wire sets available for the LS based engines. VMS Racing engineers have outdone themselves yet again!

Fitment:

             We have a Corvette/Camaro wire set that is 10.5 inches long, most Chevy/GMC/Cadillac/ Buick trucks and SUV's with V8 LS based engines use a longer 12-13 inch wire set. Measure one of your wires before you buy, if you have a factory with that is right around 10 inches buy the Camaro/Corvette wires. If it is over 12 inches then this is the correct wire set. GM used both the short and the long wires on the trucks and SUV's. Sometimes even on the same years some used the short wires and some the long wires. Only way to know which one you need is with the VIN number, or by measuring them. We have no access to the GM VIN data so you will need to measure one wire.

VMS engineers designed this to be the ULTIMATE set of LS series wires for many reasons:

1- 100% PURE SILICONE insulating jacket material: Jacket is made of TC-1500-HS high strength aerospace silicone rubber. These wires will withstand 600 degrees of heat! WORKS GREAT WITH HEADERS!
2 - LOW RESISTANCE WHILE BEING EMI AND RFI SUPPRESSED: 2.5MM conductor with stainless steel windings wound at 200 turns per inch. Just .5K OHMS per foot. Lowest Resistance possible while still maintaining necessary RFI suppression. NO MORE HEARING YOU ENGINE THROUGH THE RADIO!
3- Stainless Steel TRIPLE crimped terminals: TRIPLE CRIMPED stainless steel snap lock terminals! Exclusive triple crimped plug terminals, most wires are single crimped, better ones are double crimped, VMS ones are triple crimped! NO MORE PULLING THE PLUG BOOT AND THE TERMINAL RIPPING OUT OF THE WIRE!
4- PERMANENTLY BONDED AND SEALED BOOTS: Boots are permanently BONDED AND SEALED to the wire. No moisture will get in, and you will not rip out the boots when you pull on the wires!

You can not buy a better wire set at any price. So why is the price so reasonable you ask? Simple, you are buying directly from the factory! There is no middleman here! Normally you would expect to pay $80-100 for a set of wire of this quality. But since we are selling directly to the consumer, you are not paying the warehouse distributor markup and then the retailer markup, which would easily double the price!