VMS Racing shift boot adapter clip WITH set screw in T-6061 billet aluminum that will fit most 2005-2014 Ford Mustang with manual transmissions including the 2005-2009 Shelby Mustang (WILL NOT FIT THE 2010-2014 SHELBY MUSTANG).
Don't limit your selection to only shift knobs with built-in boot retaining clips. From VMS Racing comes this billet aluminum shift boot retaining clip that allows you to hold the shift boot up independently on your shift knob. This allows the use of a wider variety of shift knobs on your 2005-2014 Ford Mustang.
Another major advantage is that you do not have to raise your shift knob with this boot retaining clip. Most of the shift boot adapter that are out there will make your shift knob sit 1 to 2 inches HIGHER THAN STOCK! This will make you shifts slower and less accurate. With this clip you can lower your shift knob as far down as you can, and still keep your boot in place!
Shift boot adapter is made to Work on Manual transmission vehicles ONLY.
VMS Racing shift boot adapters are manufactured of Aircraft Quality T-6061 Billet Aluminum, and then they are precision machined to exacting tolerances. After all the machining is done, the shift boot adapter is beautifully hard anodized, to ensure a long lasting finish, and to provide years of trouble free service and looks.
• Made of CNC machined T-6061 Billet Aluminum.
• Includes set screw and allen key to set desired boot height.
• Holds shifter boot up to allow the use of aftermarket shift knobs.
• Easy 5 minute install.